Precaution for Harness Repair

Solder the repaired area and wrap tape around the soldered area.

Fig 1: Precaution For Solder Repaired Area And Taped
Courtesy of SUZUKI OF AMERICA CORP.

NOTE: A fray of twisted lines must be within 110 mm (4.33 in).
Bypass connection is never allowed at the repaired area.

Fig 2: Precaution For Bypass Connection
Courtesy of SUZUKI OF AMERICA CORP.

NOTE: Bypass connection may cause CAN communication error. The spliced wire becomes separated and the characteristics of twisted line are lost.
Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communication line.