DTC Confirmation Procedure
NOTE:
- If DTC other than aimed DTC are previously detected in DTC confirmation procedure, be sure to troubleshoot DTC previously detected.
- Check to make sure that the following conditions are satisfied when using this procedure.
- -10 °C (14 °F) < ECT at engine started < 40 °C (104 °F)
- -10 °C (14 °F) < ECT < 40 °C (104 °F)
- -10 °C (14 °F) < IAT < 40 °C (104 °F)
- BARO > 75 kPa (0.8 kgf/cm2, 10.8 psi, 0.75 bar)
- Start engine and warm up to normal operating temperature.
- Run engine at idle speed for 2 min.