Electronic Brake Control Module Replacement

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Electronic Brake Control Components

Courtesy of SUZUKI OF AMERICA CORP.

ELECTRICAL CENTER AND JUNCTION BLOCK TABLE

Callout	Component Name
Preliminary Procedures Place the ignition switch in the OFF position. Remove the underhood electrical center. Refer to UNDERHOOD ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENT . Clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any dirt or debris.
1	Electronic Brake Control Module (EBCM) Electrical Connector Tip: Release the locking tab and rotate the electrical connector cover upward to release.
2	EBCM to Brake Pressure Modulator Valve (BPMV) Screw (Qty: 4) CAUTION: Refer to FASTENER NOTICE . Tightening torque 3 N.m (27 lb in) Tip: Tighten the screws in a cross pattern.
3	Electronic Brake Control Module
4	EBCM to BPMV Seal (Qty: 12) If installing a new EBCM, program the EBCM. Refer to CONTROL MODULE REFERENCES . Without starting the engine, place the ignition switch in the ON position. Perform the DIAGNOSTIC SYSTEM CHECK - VEHICLE DIAGNOSTIC INFORMATION . Observe the feel of the brake pedal after performing the diagnostic system check. If the pedal now feels spongy, air may have been in the secondary circuit of the brake modulator assembly, which may have been introduced into the primary circuit. If the pedal feels spongy, perform the ANTI-LOCK BRAKE SYSTEM AUTOMATED BLEED PROCEDURE .