Diagnostic Aids
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
- Use the DATA LINK REFERENCES to identify the high speed GMLAN serial data modules.
- This test is used for a total high speed GMLAN communication failure. If only one module is not communicating and sets no DTC, ensure that the vehicle is equipped with the module, then use DTC U0100-U0299 for diagnostics.
- An open in the DLC ground circuit terminal 5 will allow the scan tool to operate to set up the vehicle on the tool and then not communicate with the vehicle. When the scan tool is to the point of communicating with the vehicle, a message on the scan tool will indicate "no CANdi module detected" and will not communicate.
- The engine will not start when there is a total malfunction of the high speed GMLAN serial data bus. The following conditions may cause a total loss of high speed GMLAN data communication:
- A short between high speed GMLAN (+) and high speed GMLAN (-) circuits
- Any of the high speed GMLAN serial data circuits shorted to ground or voltage
- A module internal malfunction that causes a short to voltage or ground on the high speed GMLAN circuits
- Use the DMM MIN/MAX function to capture/locate intermittent conditions.