LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2010 >> SX4 Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Continuously Variable Transaxle (CVT)) >> Diagnostic Information and Procedures >> Stall Test >> Notes

Stall Test: Notes

WARNING: This page is about a different variant/trim than selected.

This test is to check overall performance of CVT and engine by measuring stall speed at "D" and "R" ranges.

CAUTION:
  • Do not run engine at stall more than 5 seconds continuously, or fluid temperature may rise excessively high.
  • After performing stall test, be sure to leave engine running at idle for longer than 1 minute before another stall test.
  1. Check CVT fluid level.
  2. Apply parking brake and block wheels.
  3. Install tachometer.
  4. Start engine with select lever shifted to "P" range.
  5. Depress brake pedal fully.
  6. Shift select lever to "D" range and depress accelerator pedal fully while watching tachometer. Read engine RPM quickly when it has become constant (stall speed).
  7. Release accelerator pedal immediately after stall speed is checked.
  8. In the same way, check stall speed in "R" range.
  9. Stall speed should be within the following specification.

    Engine stall speed 

    Standard: 2,300 - 2,500 RPM 

scientia non olet · About LEMON Manuals