LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2010 >> SX4 Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Continuously Variable Transaxle (CVT)) >> Diagnostic Information and Procedures >> DTC P0871: Transmission Fluid Pressure Sensor/Switch "C" Circuit Range/Performance >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
WARNING:
  • When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
  • Road test should be carried out with 2 persons, a driver and a tester, on a level road.
NOTE:
  • If DTC other than aimed DTC are previously detected in DTC confirmation procedure, be sure to troubleshoot DTC previously detected.
  • Check that the following conditions are satisfied when using this procedure.
    • Battery voltage > 10.5 V
    • 0.5 < Gear ratio < 1.0
  1. Drive with 30 - 50 km/h (19 mile/h - 31 mile/h) constantly for 40 sec. or more at "D" range. (Keep throttle valve opening constantly in this step).
  2. Stop vehicle and turn ignition switch to OFF position.
  3. Repeat Step  1) through  2) twice.
  4. Turn ignition switch to ON position.
scientia non olet · About LEMON Manuals