LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2010 >> SX4 Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Continuously Variable Transaxle (CVT)) >> Diagnostic Information and Procedures >> DTC P0707: Transmission Range Sensor Circuit Low >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
WARNING:
  • When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
  • Road test should be carried out with 2 persons, a driver and a tester, on a level road.
NOTE:
  • If DTC other than aimed DTC are previously detected in DTC confirmation procedure, be sure to troubleshoot DTC previously detected.
  • Check that the following conditions are satisfied when using this procedure.
    • Battery voltage > 10.5 V
  1. Drive vehicle at more than 10 km/h (6 mile/h) for 20 sec.
  2. Stop vehicle and turn ignition switch to OFF position.
  3. Repeat Step  1) through  2) twice.
  4. Turn ignition switch to ON position.
scientia non olet · About LEMON Manuals