LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2009 >> Equator RMZ-4 >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System (VQ40DE) - (5 Of 5) >> ASCD Brake Switch Circuit Check >> Component Inspection >> Stop Lamp Switch

Stop Lamp Switch

  1. Turn ignition switch OFF.
  2. Disconnect stop lamp switch harness connector.
  3. Check harness continuity between stop lamp switch terminals 1 and 2 under the following conditions.
    Fig 1: Checking Harness Continuity Between Stop Lamp Switch Terminals 1 And 2
    G06441666Courtesy of SUZUKI OF AMERICA CORP.
    CONTINUITY SPECIFICATION

    Condition Continuity
    When brake pedal: Fully released. Should not exist.
    When brake pedal: Slightly depressed. Should exist.

    If NG, adjust stop lamp switch installation, refer to [BRAKE PEDAL INSPECTION AND ADJUSTMENT ], and perform step  3 again.

scientia non olet · About LEMON Manuals