LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2009 >> Equator RMZ-4 >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System (VQ40DE) - (2 Of 5) >> DTC P0442: EVAP Control System >> DTC Confirmation Procedure >> With SDT

With SDT

  1. Turn ignition switch ON.
  2. Turn ignition switch OFF and wait at least 10 seconds.
  3. Turn ignition switch ON and select "Data list" mode with SDT.
  4. Check that the following conditions are met.

    COOLAN TEMP/S: 0 - 70°C (32 - 158°F) 

    INT/A TEMP SE: 0 - 30°C (32 - 86°F) 

  5. Select "EVP SML LEAK P0442/P1442" of "EVAPORATIVE SYSTEM" in "DTC work support" mode with SDT.

    Follow the instructions displayed.

    NOTE: If the engine speed cannot be maintained within the range displayed on the SDT screen, go to [BASIC INSPECTION ].
  6. Check that "OK" is displayed.

    If "NG" is displayed, refer to [P0442 EVAP CONTROL SYSTEM ].

    NOTE: Check that EVAP hoses are connected to EVAP canister purge volume control solenoid valve properly.
scientia non olet · About LEMON Manuals