LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2009 >> Equator RMZ-4 >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System (VQ40DE) - (2 Of 5) >> DTC P0441: EVAP Control System >> DTC Confirmation Procedure >> With SDT

With SDT

  1. Start engine and warm it up to normal operating temperature.
  2. Turn ignition switch OFF and wait at least 10 seconds.
  3. Turn ignition switch ON.
  4. Turn ignition switch OFF and wait at least 10 seconds.
  5. Start engine and let it idle for at least 70 seconds.
  6. Select "PURG FLOW P0441" of "EVAPORATIVE SYSTEM" in "DTC CONFIRMATION" mode with SDT.
  7. Touch "START".

    If "COMPLETED" is displayed, go to step  7.

  8. When the following conditions are met, "TESTING" will be displayed on the SDT screen. Maintain the conditions continuously until "TESTING" changes to "COMPLETED". (It will take at least 35 seconds.)
    SELECTOR LEVER POSITION

    Selector lever Suitable position
    VHCL SPEED SE 32 - 120 km/h (20 - 75 MPH)
    ENG SPEED 500 - 3, 000 RPM
    B/FUEL SCHDL 1.3 - 9.0 msec
    COOLAN TEMP/S 70 - 100°C (158 - 212°F)

    If "TESTING" does not change for a long time, retry from step  2.

  9. Check that "OK" is displayed after touching "DTC check". If "NG" is displayed, refer to [P0441 EVAP CONTROL SYSTEM ].
scientia non olet · About LEMON Manuals