LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2007 >> XL7 Base, AWD >> Repair and Diagnosis >> Transmission >> Automatic Transmission >> Repair Instructions >> Oil Cooler Line Replacement >> Installation Procedure

Installation Procedure

Fig 1: Identifying Transaxle Oil Cooler Line Assembly
G04845980Courtesy of SUZUKI OF AMERICA CORP.
  1. Install the transaxle oil cooler lines into the vehicle.
  2. Install the transaxle oil cooler line assembly (1) to the transaxle.
    CAUTION: Refer to FASTENER NOTICE .
  3. Install the transaxle oil cooler line assembly nut (2).

    Tightening torque 

    Tighten the transaxle oil cooler lines to 9 N.m (80 lb in)  .

  4. Connect the lower transaxle oil cooler line to the radiator.
  5. Engage the transaxle oil cooler lines with the fan shroud by snapping in place.
  6. Lower the vehicle.
    Fig 2: Identifying Upper Transaxle Oil Cooler Line
    G04845981Courtesy of SUZUKI OF AMERICA CORP.
  7. Connect the upper transaxle oil cooler line to the radiator.
    NOTE: DEXRON®III automatic transmission fluid is not compatible with this transaxle. If DEXRON®III ATF is used, transaxle failure will result. This transaxle uses GM T-IV fluid P/N 88900925.
  8. Add fluid to the transaxle. Refer to the TRANSMISSION FLUID CHECK .
  9. Start the engine a check for leaks.
scientia non olet · About LEMON Manuals