Installation Procedure

NOTE: If a new steering column is being installed then transfer the position of the alignment marks from the old component to the same location on the new component. Failure to transfer the alignment marks may result in an off-center steering wheel after installation.

Install the steering column into position in the vehicle.

Fig 1: Identifying Steering Column Upper Support Bracket Bolts
Courtesy of SUZUKI OF AMERICA CORP.

CAUTION: Refer to FASTENER NOTICE .
Install the steering column upper support bracket bolts (1).
Tightening torque

Tighten the bolts to 25 N.m (18 lb ft).

Fig 2: Identifying Steering Column Lower Support Bracket Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Install the steering column lower support bracket bolt (1).
Tightening torque

Tighten the bolt to 25 N.m (18 lb ft).
Connect the intermediate steering shaft to the steering column. Refer to INTERMEDIATE STEERING SHAFT REPLACEMENT .
Connect the electrical connectors as needed.
Install the driver knee bolster reinforcement. Refer to DRIVER KNEE BOLSTER REINFORCEMENT REPLACEMENT .
Install the inflatable restraint steering wheel module coil. Refer to INFLATABLE RESTRAINT STEERING WHEEL MODULE COIL REPLACEMENT .