LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2007 >> Swift + >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls & Fuel - 1.6L - Introduction (2 Of 2) >> Repair InstructionsEngine Control Module Replacement >> Ignition Coil ReplacementRemoval Procedure >> Installation ProcedureSpark Plug Wire Inspection

Installation ProcedureSpark Plug Wire Inspection

    Fig 1: View of EI System Ignition Coil
    GM1289500Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the EI system ignition coil into the mounting location and install the retaining nuts.

    Tighten:  Tighten the EI system ignition coil retaining nuts to 10 N.m (89 lb in).

  2. Connect the EI system ignition coil connector.
  3. Connect the negative battery cable.
scientia non olet · About LEMON Manuals