LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2007 >> Swift + >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls & Fuel - 1.6L - Introduction (2 Of 2) >> Repair InstructionsEngine Control Module Replacement >> Air Cleaner Inlet Duct ReplacementRemoval Procedure >> Installation ProcedureAir Cleaner Element Replacement

Installation ProcedureAir Cleaner Element Replacement

    Fig 1: Locating Intake Ducting To Engine
    GM1241530Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: An improperly installed air cleaner intake duct or breather tube will cause incorrect sensor readings resulting in MIL illumination or a drivability concern.
  1. Install the air cleaner intake duct.
    2. NOTE: Refer to Fastener Notice .
  2. Tighten the clamps securing the air cleaner intake duct.

    Tighten:  Tighten the clamp to 3 N.m (27 lb in).

  3. Connect the breather tube to the air cleaner intake duct.
  4. Connect the electrical connector to the IAT sensor.
scientia non olet · About LEMON Manuals