A/T Basic Check
WARNING: This page is about a different variant/trim than selected.
This check is important for troubleshooting when TCM has detected no DTC and no abnormality has been noted in visual inspection. Follow the flow table carefully.
A/T BASIC INSPECTION TABLE
| Step | Action | YES | NO |
|---|---|---|---|
| 1 | Was "A/T System Check" preformed? | Go to Step 2. | Go to A/T SYSTEM CHECK . |
| 2 | Perform ROAD TEST Is it OK? |
Go to Step 3. | Proceed to TROUBLESHOOTING in Road Test. |
| 3 | Perform MANUAL ROAD TEST Is it OK? |
Go to Step 4. | Proceed to TROUBLESHOOTING in Manual Road Test. |
| 4 | Perform ENGINE BRAKE TEST Is it OK? |
Go to Step 5. | Proceed to TROUBLESHOOTING in Engine Brake Test. |
| 5 | Perform STALL TEST Is it OK? |
Go to Step 6. | Proceed to TROUBLESHOOTING in Stall Test. |
| 6 | Perform TIME LAG TEST Is it OK? |
Go to Step 7. | Proceed to TROUBLESHOOTING in Time Lag Test. |
| 7 | Perform LINE PRESSURE TEST Is it OK? |
Go to Step 8. | Proceed to TROUBLESHOOTING in Line Pressure Test. |
| 8 | 1) Proceed to TROUBLE DIAGNOSIS 1 in A/T Symptom Diagnosis. Is trouble identified? |
Repair or replace faulty parts. | Go to Step 9. |
| 9 | 1) Proceed to TROUBLE DIAGNOSIS 2 in A/T Symptom Diagnosis. Is trouble identified? |
Repair or replace faulty parts. | Proceed to TROUBLE DIAGNOSIS 3 in A/T Symptom Diagnosis. |