Steering Column Assembly Removal And Installation: Installation

Reference: CHECKING STEERING COLUMN FOR ACCIDENT DAMAGE 

1. Be sure that front wheels and steering wheel are in straight-ahead position.
2. Align flat part "A" of steering upper shaft upper joint (1) with bolt hole "B" of steering column assembly (2) as shown in the figure. Then connect steering upper shaft upper joint.
   Fig 1: Aligning Steering Upper Shaft Upper Joint Flat Part A With Bolt Hole B Of Steering Column Assembly

   Courtesy of SUZUKI OF AMERICA CORP.
3. Install steering column assembly (1) with contacting upper side of lower bracket slits to mounting bolts. Tighten steering column lower mounting nuts (3) first and then upper mounting bolts (2) to specified torque.

   Tightening torque 

   Steering column assembly mounting bolt and nut a: 25 N.m (2.5 kg-m, 18.0 lb-ft) 

   Fig 2: Identifying Steering Column Assembly Lower Mounting Nuts & Upper Mounting Bolts

   Courtesy of SUZUKI OF AMERICA CORP.
4. Install column support bracket. (if equipped)
5. Install new steering upper shaft upper joint bolt (2) and nut (1). Tighten new steering upper shaft upper joint nut (1) to specified torque.
   NOTE: Do not reuse steering upper shaft upper joint bolt and nut.
   Be sure to use new bolt and nut when installing.

   Tightening torque 

   Steering upper shaft assembly upper joint nut a: 23 N.m (2.3 kg-m, 17.0 lb-ft) 

   Fig 3: Identifying Steering Upper Shaft Upper Joint Bolt & Nut

   Courtesy of SUZUKI OF AMERICA CORP.
6. For A/T vehicle, connect shift (key) interlock cable (1) to ignition switch with ignition switch turned at ACC position.

   And then turn ignition switch LOCK position.

   Fig 4: Identifying Shift (Key) Interlock Cable

   Courtesy of SUZUKI OF AMERICA CORP.
7. Connect steering lock assembly connector.
8. Install washer switch referring to WINDSHIELD WIPER AND WASHER SWITCH REMOVAL AND INSTALLATION .
9. Install lighting switch. Refer to LIGHTING SYSTEMS .
10. Install immobilizer control module (ICM) referring to IMMOBILIZER CONTROL MODULE (ICM) REMOVAL AND INSTALLATION .
11. Install instrument panel under cover (1) to instrument panel.
    Fig 5: Identifying Instrument Panel Under Cover

    Courtesy of SUZUKI OF AMERICA CORP.
12. Install steering wheel and contact coil cable assembly by referring to STEERING WHEEL REMOVAL AND INSTALLATION  and CONTACT COIL CABLE ASSEMBLY REMOVAL AND INSTALLATION .
13. Connect negative (-) cable to battery.
14. After installing steering column assembly, be sure to enable air bag system by referring to ENABLING AIR BAG SYSTEM (ADVANCED AIR BAG) or ENABLING AIR BAG SYSTEM (EXCEPT ADVANCED AIR BAG) .