Connector: C45
CONNECTOR SPECIFICATION
| Terminal | Wire color | Circuit |
|---|---|---|
| 1 | BLU/YEL | A/C condenser fan motor relay output (if equipped) |
| 2 | BLK | Ground for ECM |
| 3 | PNK/BLU | Heater output of heated oxygen sensor-2 (HO2S-2) |
| 4 | GRN/YEL | No. 1 ignition coil output |
| 5 | - | - |
| 6 | BLK/ORN | Ground for ECM |
| 7 | - | - |
| 8 | - | - |
| 9 | - | - |
| 10 | - | - |
| 11 | BLU/RED | No. 4 ignition coil output |
| 12 | PNK | No. 3 ignition coil output |
| 13 | GRN/WHT | No. 2 ignition coil output |
| 14 | - | - |
| 15 | - | - |
| 16 | - | - |
| 17 | GRY/BLU | Fuel pump relay output |
| 18 | - | - |
| 19 | RED | Knock sensor signal |
| 20 | LT GRN/RED | Manifold absolute pressure (MAP) sensor signal |
| 21 | - | - |
| 22 | - | - |
| 23 | BRN/WHT | Main power supply relay output |
| 24 | - | - |
| 25 | - | - |
| 26 | - | - |
| 27 | BLK/RED | Crankshaft position (CKP) sensor (+) |
| 28 | BRN/YEL | A/C compressor relay output |
| 29 | - | - |
| 30 | WHT | Oxygen signal of heated oxygen sensor-2 (HO2S-2) |
| 31 | - | - |
| 32 | - | - |
| 33 | - | - |
| 34 | BRN | Crankshaft position (CKP) sensor (-) |
| 35 | - | - |