DTC Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
- With ignition switch turned OFF, connect scan tool to DLC.
- Turn ON ignition switch and clear DTC using scan tool.
- Start engine and warm it up to normal operating temperature.
- Drive vehicle in 2000 - 3500 RPM of engine speed for 10 minutes or more.
- Keep the vehicle speed for 10 min. (Throttle valve opening is kept constant in this step.)
- Stop vehicle and check DTC and pending DTC.