LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2007 >> Aerio Base, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine General Information And Diagnosis >> Diagnostic Information and Procedures >> DTC P0401 / P0402: Exhaust Gas Recirculation Flow Insufficient / Excessive Detected >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING:
  • When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
  • Road test should be carried out with 2 persons, a driver and a tester, on a level road.
NOTE: Check to make sure that the following conditions are satisfied when using this "DTC Confirmation Procedure".
  • Intake air temp.: Between -10°C and 70°C (14°F and 158°F)
  • Altitude (barometric pressure): 2500 m, 8202 ft or less (560 mmHg, 75 kPa or more)
  1. With ignition switch turned OFF, connect scan tool.
  2. Turn ON ignition switch and clear DTC using scan tool.
  3. Start engine and warm up to normal operating temperature. (80 - 100°C, 176 - 212°F)
  4. Drive vehicle at 40 - 62 mph (60 - 100 km/h) (engine speed; 2000 - 3000 r/min.).
  5. Keep the vehicle speed for 10 min. (Throttle valve opening is kept constant in this step.)
  6. Stop vehicle.
  7. Check if DTC / pending DTC exists using scan tool. If not, check if EGR system monitoring test has completed using scan tool. If not in both of the checks (i.e., no DTC / pending DTC and EGR system monitoring test not completed), check vehicle conditions (environmental) and repeat Steps  3 through  6.
scientia non olet · About LEMON Manuals