LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2005 >> Swift + >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 1.6L (L91) - Introduction >> Repair Instructions >> Knock Sensor (KS) Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing And Installing Knock Sensor
    GM1241935Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the KS with the bolts.

    Tighten:  Tighten the KS bolt to 20 N.m (15 lb ft).

  2. Connect the KS electrical connector.
  3. Install the intake manifold. Refer to Intake Manifold Replacement in Engine Mechanical - 1.6L.
  4. Connect the negative battery cable.
scientia non olet · About LEMON Manuals