LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 1992 >> Swift GT >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Fuel System >> Throttle Position Sensor (TPS) >> Removal & Installation (SOHC A/T)

Removal & Installation (SOHC A/T)

  1. Disconnect negative battery cable. Unplug TPS wiring harness connector. Remove mounting bolts and remove TPS from throttle body.
  2. Install throttle position sensor so its adjusting holes slightly cover mounting bolt holes. See Figure . Turn sensor so mounting holes align. Install sensor mounting bolts and finger tighten only.
  3. Clamp wiring harness securely to side of throttle body. Connect negative battery cable. Adjust TPS. See ADJUSTMENTS article in this section. Tighten TPS mounting bolts to 14-20 INCH lbs. (1.5-2.2 N.m).
scientia non olet · About LEMON Manuals