LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 1991 >> Samurai JS >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Glass/Windows/Mirrors) >> Diagnostic Information and Procedures >> Power Windows Inoperative - All >> Component Testing >> Main Power Window Switch

Main Power Window Switch

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the Main Power Window switch.
  2. Test for infinite resistance between the signal terminals 4 and 5 and the B+ circuit terminal 1 with the LR Switch in the INACTIVE position.
    • If less than infinite resistance, replace the Main Power Window switch.
  3. Test for less than 2 ohms of resistance between the signal terminal 4 and the B+ circuit terminal 1 with the switch in the UP position.
    • If greater than 2 ohms, replace the Main Power Window switch.
  4. Test for less than 2 ohms of resistance between the signal terminal 4 and the B+ circuit terminal 1 with the switch in the DOWN position.
    • If greater than 2 ohms, replace the Main Power Window switch.
  5. Test for infinite resistance between the signal terminals 2 and 3 and the B+ circuit terminal 1 with the RR Switch in the INACTIVE position.
    • If less than infinite resistance, replace the Main Power Window switch.
  6. Test for less than 2 ohms of resistance between the signal terminal 2 and the B+ circuit terminal 1 with the switch in the UP position.
    • If greater than 2 ohms, replace the Main Power Window switch.
  7. Test for less than 2 ohms of resistance between the signal terminal 3 and the B+ circuit terminal 1 with the switch in the DOWN position.
  8. If greater than 2 ohms, replace the Main Power Window switch.
  9. Test for infinite resistance between the signal terminals 7 and 6 and the B+ circuit terminal 1 with the Front Passenger Switch in the INACTIVE position.
    • If less than infinite resistance, replace the Main Power Window switch.
  10. Test for less than 2 ohms of resistance between the signal terminal 7 and the B+ circuit terminal 1 with the switch in the UP position.
    • If greater than 2 ohms, replace the Main Power Window switch.
  11. Test for less than 2 ohms of resistance between the signal terminal 6 and the B+ circuit terminal 1 with the switch in the DOWN position.
  12. If greater than 2 ohms, replace the Main Power Window switch
  13. Test for infinite resistance between the signal terminals 12 and 11 and the B+ circuit terminal 1 with the Driver Switch in the INACTIVE position.
    • If less than infinite resistance, replace the Main Power Window switch.
  14. Test for less than 2 ohms of resistance between the signal terminal 12 and the B+ circuit terminal 1 with the switch in the UP position.
    • If greater than 2 ohms, replace the Main Power Window switch.
  15. Test for less than 2 ohms of resistance between the signal terminal 11 and the B+ circuit terminal 1 with the switch in the DOWN position.
  16. If greater than 2 ohms, replace the Main Power Window switch Rear Window Switch
scientia non olet · About LEMON Manuals