LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 1989 >> Sidekick JA, Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Remove/Install/Overhaul >> Throttle Body >> Installation

Throttle Body: Installation

  1. Install new throttle body base gasket on intake manifold. Install throttle body and tighten mounting bolts to 14-20 ft. lbs. (18-28 N.m).
    NOTE: On models with automatic transmission, ensure fuel heater plate is installed under throttle body.
  2. Connect fuel feed pipe with new "O" ring. Tighten fuel feed pipe bolts to 71-106 INCH lbs. (8-12 N.m). Connect fuel return line to fuel pressure regulator.
  3. To check for fuel leaks, plug in connector "A" to control relay. Ensure ignition is off. Connect jumper wire between Pink/Black and Black/White wires of relay. See Figure . Turn ignition on, with engine off. This will activate fuel pump.
  4. Check for fuel leaks at throttle body. If no leaks, install remaining components. Refill cooling system.
NOTE: To adjust throttle position sensor, see ADJUSTMENTS article in this section.
scientia non olet · About LEMON Manuals