Inspection Mode 3

Diagnostic procedure:

1. Using the Subaru Select Monitor, perform the clear memory of [Door Mirror (Driver)] or [Door Mirror (Passenger)] and wait for 10 seconds or more. Ref. to COMMON (DIAGNOSTICS)>CLEAR MEMORY .
2. Read the DTC of [Door Mirror (Driver)] or [Door Mirror (Passenger)] using Subaru Select Monitor and check that the DTC is not displayed. Ref. to DOOR MIRROR (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .
   NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs. After solving the DTC, repeat from step  1.
3. Operate the remote control mirror switch to check that the mirror surfaces of outer mirror (driver's seat) and outer mirror (passenger's seat) can be adjusted manually.
   NOTE: Perform diagnostics with phenomenon in DOOR MIRROR (DIAGNOSTICS) if there is a fault in manual adjustment of the mirror surface. Ref. to DOOR MIRROR (DIAGNOSTICS)>DIAGNOSTICS WITH PHENOMENON>LIST .
4. Using the Subaru Select Monitor, check the following items under the [Data Monitor] of [Door Mirror (Driver)] or [Door Mirror (Passenger)] and check if the display changes according to the mirror surface change due to mirror surface switch operation. Ref. to DOOR MIRROR (DIAGNOSTICS)>DATA MONITOR .
   • Mirror Sensor Current Vertical Position
   • Mirror Sensor Current Horizontal Position
   NOTE: If the display does not change corresponding to the mirror surface switch operation, perform the following operation.

   1. Turn the ignition switch to OFF.
   2. Remove the outer mirror control module fuse and reconnect it.
   3. Turn the ignition switch to ON, and wait for 10 seconds or more.
5. Read the DTC of [Door Mirror (Driver)] or [Door Mirror (Passenger)] using Subaru Select Monitor and check that the DTC is not displayed. Ref. to DOOR MIRROR (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .
   NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs. After solving the DTC, repeat from step  1.