Section 93 (Sunroof System): Sunshade: Installation
WARNING: This page is about a different car, the 2024 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
- Install the shade assembly.
- Insert the shade assembly boss article (b) into the plate (a).
- Insert the shade assembly (a) into the housing (b).CAUTION:
- Make sure that the lock pin (c) is inserted in the direction that allows you to pull it out downward.
- Check that the shade assembly surface has no large undulating part.
- Insert the shade assembly (a) into the housing (b) while pressing in the center shaft using a flat tip screwdriver.
- Pull out the lock pin (a).
- Insert the shade assembly boss article (b) into the plate (a).
- Install the trim panel sub assembly. Ref. to EXTERIOR/INTERIOR TRIM>ROOF TRIM>INSTALLATION .
- Remove the stereo camera cover assembly. Ref. to EYESIGHT>STEREO CAMERA>INSTALLATION .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
- Install the lid assembly rear. Ref. to SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF)>GLASS LID INSTALLATION>GLASS LID .
- Perform reinitialization. Ref. to SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF)>SUNROOF CONTROL SYSTEM>OPERATION>REINITIALIZATION OF SHADE CONTROL MODULE .