Rear Brake Pad: Installation

WARNING: This page is about a different car, the 2023 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Before installation, remove mud and foreign matter from the disc brake assembly rear.
Check that the ground terminal is disconnected from the battery sensor.

Install the pad COMPL.
Install the caliper body.
CAUTION: Make sure that the adapter cord EPB connector is securely installed.

Tightening torque:

25 N.m (2.5 kgf-m, 18.4 ft-lb)
Install the brake hose bracket and pad clip.
Tightening torque:

Brake hose bracket: 33 N.m (3.4 kgf-m, 24.3 ft-lb)
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Using the Subaru Select Monitor, exit the brake maintenance mode. Ref. to PARKING BRAKE>PARKING BRAKE SYSTEM>OPERATION>BRAKE MAINTENANCE MODE .
After the operation is completed, apply and release the parking brake five times and ensure that the brake operates normally.
Install the rear wheels.
Tightening torque:

120 N.m (12.2 kgf-m, 88.5 ft-lb)