LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2025 >> Forester Wilderness >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Airbag System) >> Roll Connector >> Removal

Roll Connector: Removal

WARNING: This page is about a different car, the 2023 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  1. Set the steering wheel to the straight-ahead position.
  2. Turn the ignition switch to OFF.
  3. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  4. Remove the driver's airbag module. Ref. to AIRBAG SYSTEM>DRIVER'S AIRBAG MODULE>REMOVAL .
  5. Remove the steering wheel. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>STEERING WHEEL>REMOVAL .
  6. Remove the column cover assembly. Ref. to WIPER AND WASHER SYSTEMS>COMBINATION SWITCH (WIPER)>REMOVAL .
  7. Remove the steering roll connector assembly.
    CAUTION: Make sure that the steering roll connector is not turned from the original position.
    1. Disconnect the connector under the steering roll connector.
    2. Release the claws and remove the steering roll connector assembly.
    G11255151Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the sensor assembly VDC steering.
    1. Release the claws and remove the sensor assembly VDC steering (b) from the steering roll connector (a).
      G13225345Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals