Transfer Reduction Driven Gear: Installation
WARNING: This page is about a different car, the 2024 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
- Select the transfer reduction driven gear shim.
- Using the ST, measure the height "H1" from the ST end face to the ball bearing catch surface.
Preparation tool:
ST: GAUGE (499575600)
(A) Measurement surface - Install the transfer reduction driven gear to the intermediate case.
- Using the ST, measure the height "H2" from the end face of the ball bearing outer ring to the ST.
Preparation tool:
ST: GAUGE (499575600)
(A) Measurement surface - Using the following calculation, calculate an appropriate thickness "T" of the transfer reduction driven gear shim.
NOTE: Adjust using 0 to 2 pieces.T = (H1 - 15 mm (0.6 in)) - (H2 + 15 mm (0.6 in)) - 0.05 - 0.25 mm (0.002 - 0.010 in)
T Transfer reduction driven gear shim thickness (mm (in)) H1 Measured value (mm (in)) of step (1) H2 Measured value (mm (in)) of step (3) 15 mm (0.6 in) Thickness of ST 0.05 - 0.25 mm (0.002 - 0.010 in) Clearance specification - Using the ST, measure the height "H1" from the ST end face to the ball bearing catch surface.
- Install the transfer reduction driven gear.
- Install the transfer clutch. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>TRANSFER CLUTCH>INSTALLATION .