Front Reduction Driven Gear: Disassembly
WARNING: This page is about a different car, the 2024 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the front reduction driven shaft.
(A) Front reduction driven shaft (B) Front reduction driven gear - Remove the seal rings.
- Remove the ball bearing.
- Tap the ball bearing outer race to remove through the hole of front reduction driven shaft using the round bar with diameter of 7 mm (0.28 in).
NOTE: Remove by tapping the entire circumference equally. - Remove the snap ring, and then remove the retaining plate, drive plate, driven plate and dish plate.
NOTE:
In order to avoid installing the dish plate in the wrong direction, paint a mark before removal.
| (A) | Snap ring |
| (B) | Retaining plate |
| (C) | Drive plate |
| (D) | Driven plate |
| (E) | Dish plate |
| (F) | Front reduction driven gear |