CVT Transaxle System (Tr690): General Description: Preparation Tool: Other

	REMARKS
Oil pan seal cutter	Used for removing oil pan.
Circuit tester	Used for measuring resistance, voltage and current.
Thickness gauge	Used for various inspections.
Caliper	Used for measuring the dimension.
Spring scale	Used for measuring the initial load of the drive pinion.
Micrometer	Used for adjusting the drive pinion shim.
TORX® E10	Used for removing and installing the stud bolts.
TORX® T70	Used for removing and installing the drain plug.
Ko-ken 3/8 12-point 27 mm deep socket (part No. 3305M-27)	Used for removing and installing the secondary pressure sensor.
Angle gauge	Used for installing the drive plate.
Dial gauge	Used for measuring backlash. (Lever type) NOTE: Used together with magnet stand. Used for measuring clutch clearance. (Spindle type) NOTE: Used together with magnet stand.

Magnet stand

Used for measuring backlash.
NOTE: Used together with the dial gauge (lever type).
Used for measuring clutch clearance.
NOTE: Used together with the dial gauge (spindle type).