LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2024 >> WRX Base >> Repair and Diagnosis >> Suspension >> Front Suspension System And Wheel Alignment (2) >> Stabilizer >> Removal >> Stabilizer

Front Suspension System And Wheel Alignment (2): Stabilizer: Removal: Stabilizer

CAUTION: Be careful not to damage the boot of the ball joint.
  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the under guard front. Ref. to EXTERIOR/INTERIOR TRIM>FRONT UNDER COVER>REMOVAL .
  3. Remove the crossmember support rear LH. Ref. to FRONT SUSPENSION>CROSSMEMBER SUPPORT>REMOVAL .
  4. Remove the center exhaust pipe (rear). Ref. to EXHAUST (H4DOTC)>CENTER EXHAUST PIPE>REMOVAL>CENTER EXHAUST PIPE (REAR) .
  5. Remove the nut and disconnect the stabilizer link front (lower part).
    G14601727Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the stabilizer front.
    1. Remove the bolt and nut, and remove the clamp stabilizer.
    2. Remove the rubber bushing stabilizer front.
    3. Remove the stabilizer front.
    G14601728Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals