DTC P0C2D: Electric/Auxiliary Transmission Fluid Pump Control Module Feedback Signal Low: Notes
DTC detecting condition:
Detected when two consecutive driving cycles with fault occur.
Trouble symptom:
Auto Start Stop does not operate.
Wiring diagram:
- ENGINE TYPE FB
CVT control system Ref. to WIRING SYSTEM>CVT CONTROL SYSTEM>WIRING DIAGRAM>ENGINE TYPE FB .
Fuse and relay Ref. to WIRING SYSTEM>FUSE AND RELAY>LOCATION>ENGINE COMPARTMENT SIDE (ENGINE TYPE FB) .
- ENGINE TYPE FA
CVT control system Ref. to WIRING SYSTEM>CVT CONTROL SYSTEM>WIRING DIAGRAM>ENGINE TYPE FA .
Fuse and relay Ref. to WIRING SYSTEM>FUSE AND RELAY>LOCATION>PASSENGER ROOM SIDE .
- Use the check board when measuring the TCM terminal voltage and resistance.
- After servicing or replacing faulty parts, perform the last step of the basic diagnostic procedure. Ref. to AUTO START STOP (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE .
- CHECK HARNESS BETWEEN TCM AND ELECTRIC OIL PUMP CONNECTOR
.
- Turn the ignition switch to OFF.
- Disconnect the TCM connector.
- Disconnect the connector of electric oil pump.
- Measure the resistance between TCM connector and chassis ground.
Connector & terminal
ENGINE TYPE FB
(T21) No. 7 - Chassis ground:
ENGINE TYPE FA
(B67) No. 7 - Chassis ground:
Is the resistance 1 MΩ or more?
Yes: Go to 2.
No: Repair the short circuit to ground in the harness between TCM and electric oil pump connector.
- CHECK ELECTRIC OIL PUMP OPERATION STATUS SIGNAL
.
- Connect the TCM connector.
- Turn the ignition switch to ON.
- Read the waveform of electric oil pump operation status signal using an oscilloscope.
Connector & terminal
ENGINE TYPE FB
(T21) No. 7 (+) - Chassis ground (-):
ENGINE TYPE FA
(B67) No. 7 (+) - Chassis ground (-):
Is the duty ratio of electric oil pump operation status signal 100%? Ref. to AUTO START STOP (DIAGNOSTICS)>CONTROL MODULE I/O SIGNAL>WAVEFORM .
Yes: Replace the electric oil pump. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>ELECTRIC FLUID PUMP . Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>ELECTRIC FLUID PUMP .
No: Check for poor contact of TCM connector. Replace the TCM if no fault is found. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>TRANSMISSION CONTROL MODULE (TCM) . Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>TRANSMISSION CONTROL MODULE (TCM) .