Keyless Entry System

Check the keyless entry system operations as follows:

• Fully open all the door windows.
• Remove the key from the ignition switch and close all the doors including rear gate.
• Press the "LOCK" button momentarily on the keyless transmitter or the access key. Check that all the doors become locked, the buzzer sounds once, and the hazard lights flash once.

  Courtesy of SUBARU OF AMERICA, INC.

• Press the "UNLOCK" button momentarily on the keyless transmitter or the access key. Check that the driver's door is unlocked, the buzzer sounds twice, and the hazard lights flash twice.
• Also, within 5 seconds, press the "UNLOCK" button momentarily. Check that all doors (including rear gate) are unlocked, the buzzer sounds twice, and the hazard lights flash twice.

  Courtesy of SUBARU OF AMERICA, INC.

• Lock all the doors including rear gate. Check that the buzzer sounds twice, and the hazard lights flash twice, when the rear gate open button is pressed to unlock the rear gate. Press the rear gate opener button and check that the rear gate opens.

  Courtesy of SUBARU OF AMERICA, INC.

• Press the PANIC button on the keyless transmitter or the access key. Check that the panic mode (the horn keeps sounding) is initiated. Also, check that this condition continues for 30 seconds or until when any of the buttons on the keyless transmitter or the access key are pressed.

  Courtesy of SUBARU OF AMERICA, INC.

• Momentarily press the "LOCK" button on the access key or the access key with one of the doors (including the rear gate) open. Check that the buzzer sounds 5 times, and the hazard light flashes 5 times to notify the door not being fully closed. Then, close all doors. Check that all the doors become locked, the buzzer sounds once, and the hazard lights flash once.

ALARM SOUND OPERATIONAL CHECK (7-INCH TWIN TYPE) 

1. Close all doors and remove the key from the key cylinder.
2. While holding down the "UNLOCK" side of the power door lock switch, insert the key in the key cylinder.
3. To turn the alarm sound from OFF to ON, select "Keyless Entry System" in "Car" item and then set "Audible Signal" to ON.
4. Within 10 seconds, insert and take out the key for 6 times or more, and within 10 seconds after that, open and close the driver's door.
5. With the door closed, check that the hazard light flashes 3 times and that the alarm sound has been turned OFF.
6. To turn the alarm sound from OFF to ON, perform this procedure again.
7. Check that the hazard light flashes 3 times and that the alarm has been turned ON.

ALARM SOUND OPERATIONAL CHECK (11.6-INCH TYPE) 

1. Press the "Settings" button in the center information display (CID).
2. Select "Keyless Entry System" in "Car" item and set "Audible Signal" to OFF.