LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2024 >> Impreza Base >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation System & Driver Information Center >> Driver Monitoring Unit >> Installation

Driver Monitoring Unit: Installation

CAUTION: Make sure that the driver monitoring unit operates normally.
  1. Install the driver monitoring unit.
    1. Connect the connector.
    2. Install the driver monitoring unit.
  2. Install the panel center UPR.
  3. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  4. When the driver monitoring unit has been replaced, perform the following steps.
    1. Using Subaru Select Monitor, perform [Write Control module setting information] in the [Work Support] of [Driver Monitor]. Ref. to DRIVER MONITOR (DIAGNOSTICS)>WORK SUPPORT .
    2. Perform the operation according to the display screen.
    3. After the procedure is finished, it is necessary to set the Driver Monitoring System to CAN sleep status and then restart it so that the write data is properly reflected.
      NOTE:
      • To set to CAN sleep status, turn the ignition switch to OFF, and wait for a while with all the doors and the rear gate closed.
      • Turning off of the Driver Monitoring System LED can be used as a reference of CAN sleep status. After that, the write data will be reflected by activating the Driver Monitoring System function.
      • CAN sleep may not occur when the access key is located near the vehicle, so keep the access key away from the vehicle while waiting.
  5. When the driver monitoring unit has been replaced, read the [Driver Monitor] customizing information. Ref. to DRIVER MONITOR (DIAGNOSTICS)>CUSTOMIZE .
scientia non olet · About LEMON Manuals