Work Support: List

Work Support item	Contents	Remarks
Read Control module setting information	If the driver monitoring unit was replaced, it is possible to read the setting information set by the user using Subaru Select Monitor, and write it to the new driver monitoring unit. CAUTION: Never write the data into the vehicle other than the original vehicle that the data was read from.	After the procedure is finished, it is necessary to set the Driver Monitoring System to CAN sleep status and then restart it so that the write data is properly reflected. NOTE: To set to CAN sleep status, turn the ignition switch to OFF, and wait for a while with all the doors and the rear gate closed. Turning off of the Driver Monitoring System LED can be used as a reference of CAN sleep status. After that, the write data will be reflected by activating the Driver Monitoring System function. CAN sleep may not occur when the access key is located near the vehicle, so keep the access key away from the vehicle while waiting.
Write Control module setting information