LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2024 >> Forester Base >> Repair and Diagnosis >> Body & Frame >> Windows >> Window Glass & Mirrors >> Windshield Glass >> Removal >> When Using Windshield Glass Knife

When Using Windshield Glass Knife

  1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the trim panel assembly A pillar, Ref. to EXTERIOR/INTERIOR TRIM>UPPER INNER TRIM>REMOVAL .
  3. Remove the cowl panel assembly. Ref. to EXTERIOR/INTERIOR TRIM>COWL PANEL>REMOVAL .
  4. Disconnect the wiper deicer connector. (Models with wiper deicer)
  5. Remove the mirror assembly inner rearview. Ref. to GLASS/WINDOWS/MIRRORS>REARVIEW MIRROR>REMOVAL .
  6. Remove the cover EyeSight and the stereo camera. Ref. to EYESIGHT>STEREO CAMERA>REMOVAL .
  7. Remove the molding windshield from the glass windshield, and attach protective tape on the body side of the circumference of the glass windshield.
    G12408376Courtesy of SUBARU
    (a) Molding windshield
    (b) Glass windshield
    (c) Body panel
    (d) Protective tape
    (e) Adhesive
  8. Remove the glass windshield.
    1. Apply sufficient amount of soapy water to the adhesive part and insert the windshield glass knife.
    2. While holding the edges of the knife and the glass windshield at a right angle, move the windshield glass knife parallel to the edge of the glass windshield, and cut the adhesive along the surface and the edge of the glass windshield.
      CAUTION:
      • Cutting of adhesive part should be started from an area with wider gap between the glass windshield and the body  .
      • Never twist the windshield glass knife  .
      G16343628Courtesy of SUBARU
      (a) Windshield glass knife
      (b) Protective tape
      (c) Adhesive
      (d) Glass windshield
      (e) Body panel
    3. Disconnect the locating pin windshield and remove the glass windshield.
      NOTE: The locating pin windshield is bonded to the corners of glass windshield. Use piano wire to disconnect the pins  .
      G16343629Courtesy of SUBARU
      (a) Locating pin windshield
      (b) Body panel
      (c) Glass windshield
  9. Remove the locating pin. (When reusing the glass)
    1. Attach tape to the locating pin outer surface to identify the installation position.
      G13226617Courtesy of SUBARU
    2. Using a scraper, etc., remove locating pins (2 places).
      CAUTION:
      • Do not remove the tape because it is used to refer to the installation position  .
      • Be careful not to damage the glass windshield during operation  .
scientia non olet · About LEMON Manuals