Secondary Pressure Sensor: Installation

CAUTION: If water or oil contacts the connector terminal of secondary pressure sensor, replace it with a new part.

Install a new O-ring to the secondary pressure sensor.
NOTE: Apply CVTF to the O-rings.
Install the secondary pressure sensor.
1. Install the secondary pressure sensor.
  Tightening torque:
  
  13 N.m (1.3 kgf-m, 9.6 ft-lb)
2. Connect the connector.
Install the front exhaust pipe. Ref. to EXHAUST (H4DO)>FRONT EXHAUST PIPE>INSTALLATION .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Check the CVTF level. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>CVTF>INSPECTION .