LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2024 >> Ascent Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag System >> Driver's Airbag Module >> Removal

Driver's Airbag Module: Removal

CAUTION: Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  1. Set the steering wheel to the straight-ahead position.
  2. Turn the ignition switch to OFF.
  3. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  4. Remove the driver's airbag module.
    1. Using a hexagon wrench etc. wrapped by protective tape, insert the snap pins and release the locks (three locations).
      G16390191Courtesy of SUBARU OF AMERICA, INC.
    2. Disconnect the horn harness and airbag connector, and remove the driver's airbag module. Ref. to AIRBAG SYSTEM>AIRBAG CONNECTOR>PROCEDURE>DRIVER'S AIRBAG MODULE, CURTAIN AIRBAG MODULE & SECOND ROW SEAT BELT PRETENSIONER .
      G11245795Courtesy of SUBARU OF AMERICA, INC.
      G11245796Courtesy of SUBARU OF AMERICA, INC.
        Meaning of pictograms indicated on the label
      (a) Flammable explosive substance encapsulated parts; be careful of handling.
      (b) Indicates that this part is an airbag module.
      (c) Before handling, always refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM" in the service articles.
        For the disposal procedures of the airbag modules, refer to "Airbag Module Disposal".
      (d) Do not disassemble the airbag module.
scientia non olet · About LEMON Manuals