DTC P0045: Turbocharger/Supercharger Boost Control "A" Circuit/Open: Notes

-
DTC detecting condition:

Immediately at fault recognition

Trouble symptom:
- Poor driving performance
- Poor acceleration
Wiring diagram:

Engine Electrical System Ref. to WIRING SYSTEM>ENGINE ELECTRICAL SYSTEM .

G16446242

Courtesy of SUBARU OF AMERICA, INC.

CAUTION: Use the check board when measuring the ECM terminal voltage and resistance. Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>GENERAL DESCRIPTION>PREPARATION TOOL>HOW TO USE CHECK BOARD .

NOTE: After the faulty parts are repaired or replaced, perform the final check in Basic Diagnostic Procedure. Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .

CHECK HARNESS BETWEEN ECM AND ELECTRONIC WASTEGATE VALVE CONNECTOR (OPEN) .
1. Turn the ignition switch to OFF.
2. Disconnect the connector from electronic wastegate valve.
3. Disconnect the ECM connector.
4. Measure the resistance between ECM connector and electronic wastegate valve connector.
  Connector & terminal
  
  (E159) No. 18 - (E30) No. 6:
  
  (E159) No. 26 - (E30) No. 4:
Is the resistance less than 1 Ω?

Yes: Go to 2.

No: Repair the open circuit in harness between ECM connector and electronic wastegate valve connector.
CHECK FOR POOR CONTACT .
Check for poor contact in ECM and electronic wastegate valve connector.

Is there poor contact in ECM or electronic wastegate valve connector?

Yes: Repair the poor contact of ECM or electronic wastegate valve connector.

No: Replace the turbocharger. Ref. to INTAKE (INDUCTION) (H4DOTC)>TURBOCHARGER>REMOVAL .