LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2023 >> WRX GT >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Fuel Injection System) >> Crankshaft Position Sensor >> Inspection >> Crankshaft Position Sensor

Crankshaft Position Sensor

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY
  2. Prepare an oscilloscope.
  3. Disconnect the connector from ECM. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DOTC)>ENGINE CONTROL MODULE (ECM)>REMOVAL 
  4. Attach the ST between the ECM, engine wiring harness and the bulkhead wiring harness. Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>GENERAL DESCRIPTION>PREPARATION TOOL>HOW TO USE CHECK BOARD

    Special tool: 

    CHECK BOARD (18460AA190)

  5. Connect the probe to ST.
    G14600894Courtesy of SUBARU OF AMERICA, INC.
    G14601017Courtesy of SUBARU OF AMERICA, INC.
    Terminal No. Probe
    (E52) No. 4 +
    (B61) No. 63 -
  6. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY
  7. Start the engine and let it idle.
  8. Check the waveforms and voltage.
    NOTE:

    For waveform and voltage, refer to "Control Module (ECM) I/O Signal". Ref. to  ENGINE (DIAGNOSTICS) (H4DOTC)>CONTROL MODULE I/O SIGNAL>ELECTRICAL SPECIFICATION 

  9. After inspection, install the related parts in the reverse order of removal.
NOTE:

For installation procedures of ECM connectors, refer to Engine Control Module (ECM). Ref. to  FUEL INJECTION (FUEL SYSTEMS) (H4DOTC)>ENGINE CONTROL MODULE (ECM)>INSTALLATION  

scientia non olet · About LEMON Manuals