Sunroof Motor: Installation
CAUTION:
When installing the sunroof motor, be careful not to move the cable assembly.
- Install the motor assembly and connect the connector.
Tightening torque:
3 N.m (0.3 kgf-m, 2.2 ft-lb)
- Install the light assembly map. Ref. to LIGHTING SYSTEM>SPOT MAP LIGHT>INSTALLATION .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
- Perform the initialize operation. Ref. to SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF)>SUNROOF CONTROL SYSTEM>OPERATION>INITIALIZE OPERATION .
- Check the operation of sunroof by following the table below.
| Operation | Switch position |
|---|---|
| (1) Completely close the glass lid. | Close |
| (2) Tilt up the glass lid to the top position. | Tilt up |
| (3) Completely close the glass lid. | Tilt down |
| (4) Completely open the glass lid. | Open |
| (5) Completely close the glass lid. | Close |