Adjustment Value Clear

Perform when replacing stereo camera. (Do not perform when performing stereo camera re-adjustment and inspection)

1. Using the Subaru Select Monitor, select [Clear adjustment value] in [Work Support] of [EyeSight]. Ref. to COMMON (DIAGNOSTICS)>WORK SUPPORT .
2. After [Clear the adjustment value. CAUTION! Perform this only under the conditions listed in the service manual.] is displayed, select [OK].
   NOTE: After camera adjustment, the function will be enabled, when the ignition switch is turned to OFF and the system is restarted.
3. When [Clearing adjustment value...] is displayed, wait until it finishes.
4. When the adjustment value clear operation is finished correctly, [Adjustment value clear OK! Adjustment value clear is completed. Please to IG OFF more than 5 seconds. (CODE 1F00)] is displayed. Select [OK] to finish.
   CAUTION: When [Adjustment value clearing NG! Adjustment value clearing was not effective. (CODE 1F01)] or [[4203] Communication error has occurred. Turn OFF the ignition switch and re-adjust] is displayed, check the diagnostic trouble code of stereo camera (current code, history code). Ref. to COMMON (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .
5. Turn the ignition switch to OFF and wait for approx. 5 seconds or more.
   CAUTION: If the ignition switch OFF period is short, the adjustment value clear operation cannot be performed correctly.
6. Next, perform the camera all adjustment mode (replacement/removal). Ref. to EYESIGHT>CAMERA ADJUSTMENT, INSPECTION>PROCEDURE>CAMERA ALL ADJUSTMENT MODE (REPLACEMENT/REMOVAL) .