Reprogramming Files For DTC: P0606-94 (Hybrid/EV Powertrain Control Module Processor Unexpected Operation) (03-93-24)

Publication date: 2024-05-29
Reference number: 03-93-24

REPROGRAMMING FILES FOR DTC: P0606-94 (HYBRID/EV POWERTRAIN CONTROL MODULE PROCESSOR UNEXPECTED OPERATION)

TECHNICAL SERVICE BULLETIN

Reference Number(s): 03-93-24, Date of Issue: May 29, 2024

SUBARU:

2023 Solterra

APPLICABILITY

2023MY Solterra

INTRODUCTION

This bulletin announces the availability of reprogramming files developed to address cases of P060694 (Hybrid/EV Powertrain Control Module Processor Unexpected Operation) detected by the Motor EV Control ECU. When in EV mode, and the gear selector is manually shifted to the drive selection "D", if "Power Mode" is selected and driven from a parked position using the Advanced Parking System, DTC P060694 may become inaccurately detected. This is caused by a discrepancy in the torque monitoring program. The new files contain enhanced software to optimize torque monitoring. If DTC P060694 is detected, refer to the reprogramming procedures outlined below.

PRODUCTION CHANGE INFORMATION

The reprogramming files have been incorporated into vehicle production as per the table below.

Model	Starting VIN
SOLTERRA	TBD

CUW FILE INFORMATION

MY	Model	File Description	New CID/ROM ID
2023	Solterra	NA_899854216101.cuw	899854216101

SERVICE PROCEDURE/INFORMATION

Reprogram the EV Control Unit ECU following the normal GTS + reprogramming procedures. Detailed information regarding the GTS + reprograming procedures can be found in TSB 14-30-24.

WARRANTY/CLAIM INFORMATION

For vehicles within the Basic New Car Limited Warranty period or covered by an active SAS Classic or SAS Gold, this repair may be submitted using the following claim information:

Labor Description	Labor Operation #	Labor Time	Fail Code
EV CONTROL ECU REPROGRAMMING	A800-130	0.4	EVP-48

IMPORTANT: Always note the original Calibration Identification number (CID)/ROMID the vehicle came in with on the repair order before reprogramming and, make sure to list the NEW CID/ROMID for any newly installed programming (as confirmed from the actual control module AFTER installation). The NEW CID/ROMID MUST also be noted on the repair order as this information is required for entry in the Miscellaneous Detail field during claim submission. These numbers can be read using GTS+.

NOTE: The.cuw file listings provided in this bulletin are the latest available at the time of publishing. Updates are often released thereafter without revision to the original bulletin. For this reason, it is critical to always have the latest version of GTS+.

IMPORTANT REMINDERS:

SOA strongly discourages the printing and/or local storage of service information as previously released information and electronic publications may be updated at any time.
Always check for any open recalls or campaigns anytime a vehicle is in for servicing.
Always refer to STIS for the latest service information before performing any repairs.