Roll Connector: Installation

CAUTION: Refer to "CAUTION" of "General Description" before handling the airbag system components. Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .

Install the steering roll connector.

Before attaching a new steering roll connector, apply a thin coat of grease.

NOTE: If the steering roll connector is reused, check the grease amount.
If grease is insufficient, additionally apply it.

Preparation items:

Grease: An item contained in the steering roll connector, KYODO YUSHI Multemp L or equivalent

Courtesy of SUBARU OF AMERICA, INC.

When reusing the steering roll connector, align the neutral position. Ref. to AIRBAG SYSTEM>ROLL CONNECTOR>ADJUSTMENT .
Align the position of the protrusion and install the sensor assembly VDC steering to the steering roll connector.
CAUTION: Do not rotate the steering angle sensor protrusion.

Install the steering roll connector assembly.
NOTE: Before attaching a new steering roll connector, confirm that the position is in neutral, and snap off the neutral pin.
Connect the airbag connector. Ref. to AIRBAG SYSTEM>AIRBAG CONNECTOR>PROCEDURE>DRIVER'S AIRBAG MODULE (STEERING ROLL CONNECTOR) .
Install the column cover assembly. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>STEERING COLUMN>INSTALLATION .
Install the steering wheel assembly. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>STEERING WHEEL>INSTALLATION .
Install the driver's airbag module. Ref. to AIRBAG SYSTEM>DRIVER'S AIRBAG MODULE>INSTALLATION .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Perform "VDC sensor midpoint setting mode". Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM & H/U)>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE .