Room Light: Inspection
- Measure the resistance between connector terminals.
Terminal No. Inspection conditions Standard 2 - 1 Switch OFF 1 MΩ or more Switch ON Less than 1 Ω 2 - 3 Switch door Less than 1 Ω - Apply battery voltage between the connector terminals to check the lighting condition of the light.
Terminal No. Inspection conditions Specification 2 (+) - 1 (-) 2 (+) - 3 (-) Switch OFF Light OFF Switch ON Light ON Switch door Light ON - Replace the light assembly roof if faulty is found in the inspection.NOTE: Since LED (Light Emitting Diode) is used for the room light, replace the light assembly roof if the light does not illuminate.