LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2023 >> Outback Base >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Eyesight System (Diagnostics) >> Work Support >> List

Work Support: List

Work Support item Contents Remarks
Selection of Parameter Perform writing of model registration information. Ref. to EYESIGHT>STEREO CAMERA ADJUSTMENT, INSPECTION>PROCEDURE>VEHICLE INFORMATION REGISTRATION .
Confirm on Parameter Perform reading of model registration information. Ref. to EYESIGHT>STEREO CAMERA ADJUSTMENT, INSPECTION>PROCEDURE>VEHICLE INFORMATION REGISTRATION .
Clear Active Lane Keep System Learning Value Perform when suspension parts are replaced or wheel alignment is adjusted. If the steering support function is not equipped, nothing will occur even if this operation is performed.
NOTE: After performing [Clear Active Lane Keep System Learning Value], turn the ignition switch to OFF, and wait for 10 seconds or more before turning the ignition switch to ON.
Camera All Adjustment Mode (Replacement/Removal) Perform adjustment/inspection of camera.
CAUTION: When Camera All Adjustment Mode (Replacement/Removal) is pressed mistakenly, select cancel and turn the ignition switch to OFF.
Ref. to EYESIGHT>STEREO CAMERA ADJUSTMENT, INSPECTION>PROCEDURE>CAMERA ALL ADJUSTMENT MODE (REPLACEMENT/REMOVAL) .
Forced Drive of Heater and Fan Drive the stereo camera heater and fan forcibly. Ref. to EYESIGHT>LENS HOOD>INSPECTION>STEREO CAMERA>HEATER HEATING AND COOLING FAN DRIVE TEST .
Clear adjustment value Perform when replacing stereo camera. (Do not perform when performing stereo camera re-adjustment and inspection.)
CAUTION: When Clear adjustment value is pressed mistakenly, select cancel and turn the ignition switch to OFF.
Ref. to EYESIGHT>STEREO CAMERA ADJUSTMENT, INSPECTION>PROCEDURE>ADJUSTMENT VALUE CLEAR .
EyeSight All Initialization This is a recovery measures prepared for the data failure caused by the low battery voltage during data storage to inside the stereo camera.
CAUTION: Do not usually perform this because it clears the adjustment data and/or DTCs.
Ref. to EYESIGHT>STEREO CAMERA ADJUSTMENT, INSPECTION>PROCEDURE>CAMERA ALL INITIALIZATION .