Steering Warning Light Does Not Come On: Notes
- POWER STEERING ASSIST ENABLED
Detecting condition:
- Defective combination meter
- Defective harness
Trouble symptom:
When the ignition switch is turned to ON (engine OFF), the STEERING warning light does not illuminate.
NOTE: It is operating normally if the warning light illuminates when the ignition switch is turned to ON (engine OFF), and turns off approximately two seconds after engine start.
- CHECK ILLUMINATION OF OTHER LIGHTS
.
Turn the ignition switch to ON. (Engine OFF)
Do other warning lights illuminate?
Yes: Go to 2.
No: Check the combination meter. Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER SYSTEM>INSPECTION .
- CHECK LAN SYSTEM
.
Check the LAN system. Ref. to LAN SYSTEM (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE .
Is the check result OK?
Yes: Go to 3.
No: Perform the diagnosis for LAN system.
- CHECK COMBINATION METER
.
Check the combination meter. Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER SYSTEM>OPERATION>SELF-DIAGNOSIS DISPLAY MODE .
Is the check result OK?
Yes: Current condition is normal.
No: Replace the combination meter. Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER .