Rear Disc Brake Assembly: Installation

NOTE:

Before installation, remove mud and foreign matter from the caliper body and support rear disc brake.
Check that the ground terminal of the battery sensor is disconnected.

Check each part. Ref. to BRAKE>REAR DISC BRAKE ASSEMBLY>INSPECTION .
Use new mounting bolts to install the support rear disc brake.
Tightening torque:

73 N.m (7.4 kgf-m, 53.8 ft-lb)
Install the pad COMPL.
Install the caliper body.
CAUTION: Make sure that the adapter cord EPB connector is securely installed.

Tightening torque:

25 N.m (2.5 kgf-m, 18.4 ft-lb)
Connect the brake hose rear using a new gasket.
Tightening torque:

26 N.m (2.7 kgf-m, 19.2 ft-lb)
Install the brake hose bracket.
Tightening torque:

33 N.m (3.4 kgf-m, 24.3 ft-lb)
Bleed air from the brake line. Ref. to BRAKE>AIR BLEEDING>PROCEDURE>BRAKE LINE .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Using the Subaru Select Monitor, exit the brake maintenance mode. Ref. to PARKING BRAKE>PARKING BRAKE SYSTEM>OPERATION>BRAKE MAINTENANCE MODE .
After the operation is completed, apply and release the parking brake five times and ensure that the brake operates normally.
Install the rear wheels.
Tightening torque:

120 N.m (12.2 kgf-m, 88.5 ft-lb)