LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2023 >> Forester Base >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Eyesight System >> Lens Hood >> Installation

Lens Hood: Installation

CAUTION:
  • When the stereo camera has been removed, always perform the adjustment and inspection of the stereo camera. Ref. to EYESIGHT>CAMERA ADJUSTMENT, INSPECTION .
  • Do not apply any impact to the stereo camera. Even the slightest shock will deviate the optical axis of the camera, resulting in the loss of normal operation of the camera.
  • If the lenses RH and LH are accidentally touched, or dirt or dust is accumulated on them, be sure to replace the stereo camera.
  • The cooling fan at the center and harness are easily damaged. When performing the operation, be careful not to touch them. If strong impact or force is accidentally applied, be sure to perform forced operation of the fan after installation. Ref. to EYESIGHT (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC B28C7 FAN MOTOR RPM .
  1. Install the lens hood.
    CAUTION:
    • Do not hold the insulation portion (a) of the lens hood. The elements inside may get damaged, causing malfunction.
      G14418375Courtesy of SUBARU OF AMERICA, INC.
    • Do not touch the coating surface of the lens hood. If there are scratches or dirt, the camera adjustment and inspection may not be able to be performed properly.
    1. Remove the paper covering the lens hood.
    2. Align the positioning holes of the lens hood assemblies LH and RH to the positioning pin of the camera bracket, and engage the claws.
      CAUTION: Do not press the claws of the lens hood with excessive force in order to avoid damage.
    3. Install the harness to the clamps.
    4. Connect each connector and install the connector locks.
      NOTE: Do not apply excessive tension to the harness.
    G14418378Courtesy of SUBARU OF AMERICA, INC.
  2. Install the cover EyeSight. Ref. to EYESIGHT>STEREO CAMERA>INSTALLATION .
  3. Install the overhead console. Ref. to INSTRUMENTATION/DRIVER INFO>WARNING BOX>INSTALLATION .
  4. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  5. Perform the heater heating and cooling fan drive test of the lens hood. Ref. to EYESIGHT>LENS HOOD>INSPECTION>HEATER HEATING AND COOLING FAN DRIVE TEST .
scientia non olet · About LEMON Manuals