Inspection Mode Al
| DTC | Description & trouble part | Condition | Number of driving cycles on the detecting condition |
|---|---|---|---|
| P2004 | TGV CONTROL STUCK OPEN BANK 1 | Depress the accelerator to full throttle during acceleration. | 1 |
| P2005 | TGV CONTROL STUCK OPEN BANK 2 | 1 | |
| P2006 | TGV CONTROL STUCK CLOSED BANK 1 | 1 | |
| P2007 | TGV CONTROL STUCK CLOSED BANK 2 | 1 |
WARNING:
When performing inspection mode AL on a public road, pay sufficient attention to the traffic condition and give the highest priority to safe driving.
NOTE:
- Perform the inspection mode after warming up the engine except that the engine coolant temperature at engine start is specified.
- Even if switched to the hybrid battery save mode under the following conditions, the engine may not start.
- Power from HV battery is low and reduction in SOC is slight.
- SOC is recovering due to regeneration, etc.
- Check that the battery voltage is 12 V or more and fuel remains approx. half [20 - 40 L (5.3 - 10.6 US gal, 4.4 - 8.8 Imp gal)].
- Using the Subaru Select Monitor, perform the clear memory of [Engine]. Ref. to COMMON (DIAGNOSTICS)>CLEAR MEMORY .
- Drive according to the drive pattern described below.
(1) Vehicle speed 60 km/h (37.3 MPH) (2) Deceleration for 5 seconds or more (There is no restriction to the driving operation) (3) Vehicle speed 40 km/h (24.9 MPH) (4) Engine speed 900 rpm or more (A) Press the hybrid mode switch to switch to the hybrid battery save mode. (B) Wait until the engine stalls during idling. (C) Wait for 20 seconds or more with the engine started and the accelerator fully closed. (D) Accelerate the vehicle to 60 km/h (37.3 MPH). (There is no restriction to the driving operation.) (E) Drive at a constant speed. (Step (E) may be omitted according to road conditions.) (F) With the accelerator pedal fully closed, decelerate the vehicle speed while taking at least 8 seconds and maintaining the vehicle speed at 40 km/h (24.9 MPH) or more as well as the engine speed 900 rpm or more. (G) Park the vehicle and stop the engine. (Driving method while vehicle is driven to a stop at safe place is not restricted.) NOTE: Perform (F) with the engine running. - Read the pending code using the Subaru Select Monitor or general scan tool. Ref. to COMMON (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .